AW: P38 Alpine Radio nach Batteriewechsel

dag johan

als de alpine voor de batterij de-montage NICHT - niet decodiert is worde..

dan ist 't gewest....

batterieausbau..... zegt naar de radio... let op: diebstal... blokkeren...

zonder code... werkt het niet...

veel geluk

ps
mijn nl is naar 20 jaar niet meer allerbest...


ps
mischien is de radio code achtern genoterd ?

AW: P38 Alpine Radio nach Batteriewechsel

hallo,
zitat aus dem benutzerhandbuch:

"NOTE: If an incorrect code is entered, aone
minute time delay is imposed before a
second code can be attempted. Each time a
wrong code is entered, the time delay
doubles (2 min, 4 min, 8 min, etc.) making
theft a vel)! unattractive proposition."

"Your dealer will have correctly activated the
security code before you took delivery ofthe
vehicle. This is confirmed whenever you
switch the unit on by 'CODE' appearing
BRIEFLY in the display.
If this display is absent, the radio will still
work, but will not be protected by the
security code. If this isthe case, you should
activate the code by keeping the 'up' tuning
button depressed while turning the set on (a
two-tone bleep will sound). Before activating
the code, ensure that you have the Security
Information card with the security code on it."

"If the code has not already been entered, or
power to the set has been interrupted, the
code MUST be entered before the set will
operate. Enter the code as follows:
• Switch on the radio ('CODE' appears in
the display). Press pre-set button 1.
• Press either the up ordown tuning button
(highlighted in illustration) until the first
digit of the security code appears in the
display. Press pre-set 1to store the first
digit in the unit's memory.
• Use either tuning button to select the
second digit ofthe code (correct digit
appears in the display). Press pre-set 1to
store the second digit.
• Select the third digit, again using the
tuning buttons (until the correct digit is
displayed). Press pre-set 1to store the
third digit.
• Select the final digit (the display now
shows the full four digit code). Press
pre-set 1to store the final digit."

"NOTE: If an incorrect code has been entered,
the first time delay period commences.
During the delay period, 'WAIT' appears in
the display - DO NOT switch off At the end
of the delay period, 'CODE' reappears in the
display and you can then enter the correct
code. Remember; the time delay period
doubles each time an incorrect code is
entered."